How To Install The Product; How To Access The Product - Axis Q16 serie Installationsanleitung

How to install the product

NO NO TICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
Note
• Make sure that the material is strong enough to support the weight of the camera.
• For more technical specifications, see the camera's datasheet, available on www.axis.com
1. Prepare the wall or ceiling for installation of the stand. Use the stand as a template and
mark the holes before drilling.
2. Route the network cable through the wall or ceiling. Leave approximately 30 cm (11.8
in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device,
leave approximately 30 cm (11.8 in) of cable for connecting the camera.
4. Install the stand on the wall or ceiling and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
5. Install the camera on the stand and tighten the tripod screw.
6. Optionally connect an active speaker and/or external microphone.
7. Connect the camera to the network using a shielded network cable.
8. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
- Connect an external power adapter to the power connector block. See
Connectors.
9. Check that the indicator LEDs indicate the correct conditions. See the table on for more
details. Note that the Status LED can be configured to be unlit during normal operation.
10. Optionally insert a microSD card (not included) into the SD card slot.
11. Aim the camera in the right direction and use the supplied Allen key Resitorx 20 to
tighten the ball joint.
NO TICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Settings > System > Storage in the camera web interface.

How to access the product

AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from axis.com/support
AXIS Q16 Network Camera Series
9
EN