Completing The Installation; Led Indicators - Axis 212 PTZ Installationsanleitung

Page 6

Completing the installation

1. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower to
remove dust from the lens.
2. Mount the dome casing using the supplied tamper-proof screws and screw driver.
If using the angled wall mount, hook the side of the dome casing onto the tab on the
angled wall mount (see page 4) and secure the dome casing on the other side using a
tamper-proof screw.
3. Refer to "Setting the IP address" on page 7 for information on how to assign an IP address
to the AXIS 212 PTZ.
The installation is now complete.
I/O terminal connector block
Pin Function
4 Transistor
Output
3 Digital Input
2 3.3V DC
1 GND

LED indicators

LED Color Description
Network Green Steady for connection to 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit No connection.
Status Green Shows steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to flash only when
the camera is accessed. See the online help files for more information. Go to Setup > System
Options > LED settings
Amber Steady during startup, reset to factory default or when restoring settings.
Red Slow flash for failed upgrade.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
Description
With a maximum load of 50mA and a maximum voltage of 24V DC, this output has an
open-collector NPN transistor with the emitter connected to the GND pin. If used with an
external relay, a diode must be
connected in parallel with the load, for protection against voltage
transients.
Connect to GND to activate, or leave floating (or unconnected) to
deactivate.
Can be used to power auxiliary equipment, max 50mA.
AXIS 212 PTZ Installation Guide