Connect The Accessory Audio Cable; Connection Of Headphones (Commercially Available); Connecting The Monitor To A Power Source - Sharp LL-T1815 Bedienungsanleitung

Connecting the monitor and turning the monitor on and off
2.Connect the analog and digital signal cables
(purchased separately) to the 2-input cable, then
connect to a computer.
Analog signal cable
- Paying attention to connector orientation, firmly
insert the signal cable into the PC, and then
tighten the screws at both sides.
Notes:
- When using a 2-input cable, set [INPUT-2] to [2
LINES]. (p. 21, 24)
- The monitor connected to the mini D-sub
connector of the 2-input cable may not be
automatically recognized and setup under Plug &
Play. Perform storage of setup information
manually. (p. 30)

Connect the accessory audio cable

When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the display speakers. You can also use the
headphone jack of the display.
Audio input
terminal
Audio cable
Downloaded from www.Manualslib.com
Digital signal cable
( NL-C01E, purchased separately)
Analog RGB
output terminal
Digital RGB output terminal
To audio output terminal
manuals search engine
Connection of headphones
(commercially available)
Headphones (commercially available) can be
connected.
Headphone
terminal
Headphones
Notes:
- When the headphones are connected, no sound
can be heard from the monitor speakers.
Connecting the monitor to a power
source
Power cord
13
Power terminal
AC outlet