Supplied Components; Preparing The Remote Control Unit; Attaching The Wireless Adapter - Sharp PN-L752B Installationsanleitung

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 4
 Power cord
 Remote control unit battery: 2
 Setup Manual (this manual): 1
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit

1. Place your finger on the part marked with the ▲, and
then pull the cover off.
2. See the instructions in the compartment and put in the
batteries (R03 or LR03 ("AAA" size) x 2) with their plus
(+) and minus (-) sides oriented correctly.
3. Close the cover.

Attaching the wireless adapter

1
1. Remove the bottom cover.
2. Attach a wireless adapter.
Take note of the direction of the wireless adapter.
The surface with the * mark is the front.
TIPS
• Store the removed cover and screws.
After removing the wireless adapter, put back the cover, and fasten it with the removed screws.

Supplied Components

 Touch pen: 2
 Camera mount: 1
 Camera mount screw (M3x10): 2
 Camera screw (inch thread): 1
 STB mount: 1
 STB mount screw (M3x6): 2
 Wireless adapter: 1
 USB cable: 1
 Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover the logo.
2
*
Wireless adapter
5
E