Before You Start; Assembly - Echo PB-8010 Bedienungsanleitung

Before you start

Assembly

 Read the operator's manual carefully to ensure that you assemble the product correctly.
 Never perform maintenance or assembly procedures with engine running.
 Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Install blower pipes
1. Clamp with guide loop
3. Flexible pipe
1. Elbow
1. Handle
3. Swivel pipe
WARNING
2. Clamp
2. Anti-static wire
2. Locking knob
4. Clamp
Before you start
1. Assemble clamp onto end with smaller diameter of flexible
pipe.
2. Assemble clamp with guide loop onto end with larger diam-
eter of flexible pipe. Place clamp with opening side of clip di-
rected upward.
NOTE
Clamp with cable guide loop fits elbow end of flexible pipe.
3. Insert anti-static wire through flexible pipe.
4. Assemble flexible pipe to elbow on blower. Place clamp with
guide loop. Position guide loop on outside of flexible pipe
(away from blower) and tighten clamp.
NOTE
A light lubricant may be used to ease assembly of flexible pipe
to blower elbow.
5. Position cable along the outside of elbow. Loosen locking
knob on handle. Install onto swivel pipe.
NOTE
Hang handle freely from blower to assure throttle cable is not
twisted before installing handle.
14