ResMed S8 Escape Bedienungsanleitung Seite 24

1 I
•
•
•
2 C
•
•
•
•
3 R
Grip the end of the Data Card and pull it out of the Data Card module (H-3).
4 S
Your Data Card should be stored in its mailback envelope when not in use.
5 M
A bubble mailer envelope is provided to ensure safe transportation of the Data Card.
When mailing the Data Card to your clinician:
1. Insert the Data Card into the pocket provided on the mailback envelope. Fold up
2. Place the mailback envelope containing the Data Card in the bubble mailer
3. Make sure that your clinician's name and address details are on the bubble mailer
U
SING THE
If your clinician has provided a Data Card with new device settings:
•
•
•
Note: This message only appears once. If you re-insert the Data Card after you have
updated your settings, this message is not displayed.
•
•
Downloaded from www.Manualslib.com
D C
NSERT THE ATA ARD
Switch on the S8 E
SCAPE
Hold the Data Card with the arrow facing up and insert it into the slot in the Data
Card module (H-1).
Push the card in smoothly until it stops moving (H-2) and messages start
appearing on the LCD.
D
OPY ATA ONTO THE
Data copying starts automatically when the Data Card is inserted into the Data
Card module.
The "Card Inserted Please Wait" message is displayed on the
while data is being copied. Copying takes approximately five seconds.
The "Copy Complete Remove Card" message is displayed on the LCD when
copying has finished.
Remove the Data Card from the Data Card module.
D C
EMOVE THE ATA ARD
D C
TORE THE ATA ARD
D C
AIL THE ATA ARD TO YOUR
the mailback envelope.
envelope and seal it.
envelope, and mail it back immediately.
D C
ATA ARD TO
With the device in standby (Ramp) mode, insert the Data Card into the slot on
the Data Card module. Updating will start automatically.
The "Card Inserted Please Wait" message is displayed on the LCD while updating
is in progress. Updating takes approximately five seconds.
The "Settings Success Remove Card" message is displayed on the LCD if the
settings were updated successfully.
Remove the Data Card from the Data Card module.
Store the Data Card in its mailback envelope when not in use.
manuals search engine
and wait until you see the standby (Ramp) screen.
D C
ATA ARD
C
LINICIAN
U S
PDATE ETTINGS
S8 E LCD
SCAPE
S8 M
ODULES
19