ResMed S8 Escape Bedienungsanleitung Seite 21

H
Press the Right key (Exit). This will take you back to the Patient Menu screen.
H
Press the Right key (Exit).
H
OW TO
During ramp time, the pressure increases from a low pressure to the prescribed
treatment pressure. You can set the ramp time in 5-minute intervals, from 0 minutes
(OFF) up to a maximum ramp time set by your clinician.
The standby screen displays the current ramp time in the right-hand corner. To change
the ramp time, press the Up or Down key until the desired ramp time appears.
Once a ramp time is selected, begin therapy by pressing the Start/Stop key.
When ramping begins the LCD will display the word "RAMPING", with the current
pressure indicated as dashes. Each dash is approximately equivalent to 2 cm H
example, six dashes represents approximately 12 cm H
H
OW TO CHANGE THE
If you move or travel with your
to adjust the altitude compensation setting. Changes in altitude will affect the pressure
delivered by the
You can use the Altitude setting (ALT) to specify the altitude range at which you are
using your
standby (RAMP) screen. Scroll to ALT and select Change (Left key). Press the Up or
Down keys until you see the setting option that you require.
There are four altitude settings to choose from:
•
•
•
•
For example, if you are at an altitude of 947 m, your altitude compensation setting
would be 610–1219 m, as 947 m falls within that range.
Press the Left key (Apply) to select the correct setting.
H
OW TO CHANGE THE LANGUAGE SETTING
To display menus and messages in a different language, select the
pressing the Left key in the standby (Ramp) screen. Scroll to LANG and select Change
(Left key). Press the Up or Down keys until you see the language that you require.
O
THER VIEWABLE INFORMATION
You can also view the total number of hours of treatment (USED HRS); the number
of sessions that the
software version installed on your unit (SW). Access to all of these screens is provided
via the menu. See "How to enter the menu screens" on page 15.
16
Downloaded from www.Manualslib.com
OW TO EXIT OUT OF A MENU
OW TO EXIT OUT OF AN ITEM WITHIN THE MENU
C R
HANGE THE AMP
A
LTITUDE SETTING
S8 E
SCAPE
S8 E .
Select the
SCAPE
0–609 m
610–1219 m
1220–1828 m
1829–2591 m.
S8 E
SCAPE
manuals search engine
T
IME
S8 E
to areas of different altitude, you will need
SCAPE
.
S8 E menu by pressing the Left key in the
SCAPE
was used in a usage period (USAGE); and the current
O. For
2
O pressure.
2
S8 E menu by
SCAPE