Cleaning The Rollers; Removing The Imprinter - Fujitsu fi-565PR Bedienungshandbuch

4.3. Cleaning the Rollers

When ink or dust from paper is stuck on the imprinter feed
roller surfaces, documents may not feed smoothly. To
prevent feed problems, clean the rollers' surfaces regularly.
HINT
1. Open the imprinter cover.
2. With a lint-free cloth, gently wipe off the dirt or
dust from the roller surfaces.
To clean the lower rubber rollers (total eight), rotate the
rollers by holding down the [Scan] button and [Send to]
button on the front panel of the scanner.
ATTENTION
3. Cleaning the Plastic Rollers.
Also, clean the two black plastic rollers on the inner
side of the Imprinter cover.
Rotate the rollers with your fingers gently and wipe
off any dirt or dust from the roller surface with a
lint-free cloth.
4. Confirm that all dirt and dust have been removed
from the rollers. Close the Imprinter Cover.
Downloaded from www.Manualslib.com
Recommended cleaning cycle is every 5,000 sheets.
Actual cleaning cycle may be shorter depending on
usage and documents.
Imprinter Cover
When cleaning, be careful not to touch the
metal wheels located behind the upper rollers
on the print cartridge holder cover.
Imprinter Cover
manuals search engine

4.4. Removing the Imprinter

When removing the imprinter from the scanner, refer to
"2.1. Installing the Imprinter" and remove as follows:
1. Remove the Stacker from the Imprinter.
2. Remove the black cover under the Stacker from
the Imprinter.
3. Disconnect the EXT cable from the EXT
connector of the Scanner.
4. Remove the screw that connects the scanner to
the imprinter.
5. Push up the lever located at bottom left of the
imprinter.
6. Remove the Imprinter as shown below.
7. Remove the Attachment Guide from the Scanner.
(Refer to "
How to remove the Attachment Guide
8. Replace the black cover, removed in procedure 2,
to the Scanner.
9. Replace the Stacker, removed in procedure 1, to
the Scanner.
fi-565PR Imprinter Operator's Guide | 15
"(P.6))