Installing The Print Cartridge - Fujitsu fi-565PR Bedienungshandbuch

10. Replace the Stacker (removed in procedure 2)
into the Imprinter.
11. Connect the power cable to the scanner.

2.2. Installing the Print Cartridge

Mount the print cartridge as follows:
ATTENTION
1. Confirm that the scanner is turned off.
2. To open the print cartridge cover, grasp and pull
open the center of the cover turning it towards
you, as shown below.
3. Remove by pulling the tape seal that is affixed to
the print cartridge holder and the paper guide.
4. Pinch slightly together the handles of the closing
lever to release it from its cartridge tray holder
and turn it upwards to open the tray holder.
Downloaded from www.Manualslib.com
Insert one end.
Insert the next end.
When installing or replacing the print cartridge, be
careful not to insert it out of place.
Print Cartridge Holder
manuals search engine
5. Remove the new print cartridge from its pouch.
6. Remove protection tape from the print cartridge.
Do not touch the metal part of the cartridge nor
ATTENTION
put the tape back on again.
7. Insert the print cartridge into the holder as shown
below.
Be careful not to let the print cartridge touch or
ATTENTION
catch on to the print circuit film.
8. Lower the handle lever until it locks in and fixes
the cartridge in place.
9. Position the print cartridge holder along where the
document will pass through.
The print will be located on the page properly for
your application.
fi-565PR Imprinter Operator's Guide | 7