Fujitsu fi-565PR Bedienungshandbuch Seite 10

How to remove the Attachment Guide
HINT
Pressing your fingers on the Attachment Guide,
slide it down and out to remove.
5. Remove the attached screw from the Imprinter's
rear portion.
6. Install the Imprinter to the Scanner.
To install the Imprinter to the scanner, insert the
connecting pins located on the Scanner's rear
component into the scanner's round holes.
●
ATTENTION
●
●
6 |
Downloaded from www.Manualslib.com
Screw
Connecting Pin
Do not hold the imprinter cover when carrying
or transferring it from one place to another.
Attach the imprinter firmly on to the scanner.
( Confirm that the Imprinter does not
separate from the Scanner when pulled.)
Be careful not to pinch your fingers.
manuals search engine
After installation
7. Attach the Screw to fix the Imprinter. (1 position)
8. Connect the EXT Cable to the Scanner's rear
connector.
The Imprinter will not work if the EXT cable is
ATTENTION
not connected to the Scanner. Scanning when
the EXT cable is not connected can cause
documents to jam inside the Imprinter.
9. Replace the black cover (removed in procedure 3)
to the Imprinter.
Place the hollows at the cover's bottom into the
projecting side-points inside of the imprinter.
Close the cover until it snaps in place.
Screw
EXT Cable