7- Use And Operation; Using The Actuator; General Precautions - Motorline MCBT80 Installations- Und Gebrauchsanweisung

EN

7- USE AND OPERATION

7.1-

USING THE ACTUATOR

THE ACTUATOR MAY ONLY BE OPERATED BY AN USER ACTING ACCORDING TO THE
INSTRUCTIONS CONTAINED IN THIS MANUAL AND/OR IN THE ACTUATOR CONTROL
DEVICE MANUAL (E.G.: WIND OR RAIN CONTROL UNIT).
BEFORE OPERATING THE ACTUATOR, MAKE SURE THERE ARE NO PEOPLE, ANIMALS
OR OBJECTS NEAR AND/OR UNDER THE WINDOW FRAME WHOSE SAFETY MAY BE
ACCIDENTALLY COMPROMISED (SEE PAR. 4.2).
WHILE USING THE ACTUATOR CONTROL DEVICE, THE OPERATOR MUST BE IN A SAFE
CONTROL POSITION WITH A VIEW OF THE MOVING WINDOW.
ALL THE ABOVE MAINTENANCE OPERATIONS MAY ONLY BE PERFORMED BY
COMPETENT AND QUALIFIED TECHNICAL PERSONNEL WHO SA TISFY THE
PROFESSIONAL AND TECHNICAL REQUIREMENTS ESTABLISHED BY THE LAWS IN
FORCE IN THE COUNTRY OF INSTALLATION.
8- MAINTENANCE
EN

8.1- GENERAL PRECAUTIONS

IF THE ACTUATOR WORKS INCORRECTLY, CONTACT THE MANUFACTURER.
ANY WORK ON THE ACTUATOR (E.G.: POWER CABLE, ETC.) OR ITS COMPONENTS MAY
ONLY BE CARRIED OUT BY PERSONNEL QUALIFIED BY THE MANUFACTURER.
STATEUROP DECLINES ALL LIABILITY FOR WORK PERFORMED BY UNAUTHORISED
PEOPLE
The actuator incorporates components that do not require significant routine or
extraordinary maintenance operations.
In heavy-duty conditions (e.g.: very dirty work areas, frequent use, elevated
temperature changes, load variations caused by wind or snow, etc.) make sure, at least
once every 6 months, that the actuator assembly components are clean, the fixing
systems (brackets and screws) are tight, the window frame is not deformed and the
seals are tight, and check the cables and connectors.
If any malfunctions arise after cleaning or inspection, contact the Stateurop
technical assistance service.
40 INSTALLATION AND USE INSTRUCTIONS
MCBT80
MCBT80
VER.1.0
13
REV.08.06