Electrical Connections (Wiring Diagram); Control Devices - Motorline MCBT80 Installations- Und Gebrauchsanweisung

EN 6- INSTALLATION
6.4-

ELECTRICAL CONNECTIONS (Wiring diagram)

THE ACTUATOR MAY ONLY BE CONNECTED TO THE POWER SUPPLY BY COMPETENT
AND QUALIFIED TECHNICAL PERSONNEL (ELECTRICIANS) WHO SATISFY THE
PROFESSIONAL AND TECHNICAL REQUIREMENTS ESTABLISHED BY THE LAWS IN
FORCE IN THE COUNTRY OF INSTALLATION AND WHO CAN ISSUE THE CUSTOMER
WITH A DECLARATION OF CONFORMITY COVERING THE RELATIVE CONNECTION
AND/OR SYSTEM.
BEFORE CONNECTING THE ACTUATOR TO THE POWER SUPPLY, CHECK IT IS
CORRECTLY FITTED TO THE WINDOW FRAME.
THE MAINS POWER SUPPLY TO WHICH THE ACTUATOR IS CONNECTED MUST SATISFY
THE REQUIREMENTS ESTABLISHED BY THE LAWS IN FORCE IN THE COUNTRY OF
INSTALLATION, AS WELL AS THE TECHNICAL SPECIFICATIONS INDICATED IN TAB. 1,
THE RATING PLATE AND THE "CE" MARKING (PARA 3.1). IT MUST ALSO BE
CONNECTED TO A SUITABLE EARTH CIRCUIT.
THE CROSS-SECTION OF THE MAINS LINE MUST BE PROPERLY SIZED ACCORDING TO
THE POWER INPUT (SEE RATING PLATE AND "CE" MARKING).
ANY TYPE OF ELECTRIC MATERIAL (PLUG, CABLE, TERMINALS, ETC.) USED FOR THE
CONNECTION MUST BE SUITABLE FOR USE, "CE" MARKED AND SATISFY THE
REQUIREMENTS ESTABLISHED BY THE LAWS IN FORCE IN THE COUNTRY OF
INSTALLATION.
A SECTIONING DEVICE WITH A 30 mA DIFFERENTIAL PROTECTION AND ASSOCIATED
WITH THE EARTH CIRCUIT MUST BE INSTALLED UPLINE FROM THE POWER LINE.
IT IS FORBIDDEN TO CONNECT ACTUATORS FITTED WITH DOUBLE INSULATION (MOD.
230V) TO THE EARTH CIRCUIT.
TO ASSURE EFFICIENT SEPARATION FROM THE MAINS, INSTALL AN APPROVED
TEMPORARY BIPOLAR SWITCH (PUSH-BUTTON) UPLINE OF THE DEVICE. FIT A
BIPOLAR MAIN SWITCH WITH CONTACT APERTURE OF AT LEAST 3.5 mm UP LONE OF
THE CONTROL LINE.
6.5-

CONTROL DEVICES

THE CONTROL DEVICES USED TO DRIVE THE ACTUATOR MUST SATISFY THE SAFETY
CONDITIONS ESTABLISHED BY THE LAWS IN FORCE IN THE COUNTRY OF
INSTALLATION.
38 INSTALLATION AND USE INSTRUCTIONS
MCBT80
VER.1.0
13
REV.08.06