Transducer, Installation - Balluff BTL5-H1xx-Mxxxx-B/Z-S 92/KA serie Datenblatt

BTL5-H1_ _-M_ _ _ _-B/Z-S 92/KA_ _
Micropulse Linear Transducer - Rod Style
3 Installation (cont.)
Electrical connection
BTL5...B/Z-KA05
BTL5...B/Z-S 92
11
19
Fig. 3-2: Transducer BTL5...B/Z...., Dimensions
Important Installation Notes:
The contact surface of the trans-
ducer must be completely con-
tacted by the mounting surface.
The O-ring supplied must make a
perfect pressure seal, i.e. the bevel
for the O-ring must be configured
exactly as shown in ➥ ➥ ➥ ➥ ➥ Fig. 3-3.
3.2

Transducer, Installation

The smallest permissible distance
between magnet ring and rod
mounting surface is shown in
➥ ➥ ➥ ➥ ➥ Fig. 3-2.
The transducer has either a
M18×1.5 thread or a 3/4"-16UNF
thread for mounting. The sealing is
carried cut with the O-ring supplied
at the flange facing.
4
english
Mounting
B: 30 mm
surface
Z: 2"
Magnet
0.5
Thread size: B: M18×1.5
25
86
To achieve secure mounting, use the
proper nut for the mounting thread.
When tightening the nut, do not ex-
ceed a tightening torque of 100 Nm.
For horizontal mounting of trans-
ducer with stroke lengths greater
than 500 mm, the pressure tube
Threaded hole
M18×1.5 per
ISO 6149
O-ring 15.4 × 2.1
Threaded hole
3/4"-16UNF per
SAE J475
O-ring 15.3 × 2.4
Fig. 3-3: Threaded hole for mounting the BTL with O-ring
Nominal length =
stroke
Magnet
Z: 3/4"-16UNF
should be supported or attached at
its end.
When installing in a hydraulic cylin-
der, do not allow the magnet ring to
rub against the pressure tube. The
bore diameter in the piston and cyl-
inder rod should be at least 13 mm.
Bevel for O-ring
Damping zone
(unusable area)
60
45
SW 46
Threaded hole