Service And Maintenance - Daikin J serie Installationshandbuch

Inhaltsverzeichnis

Verfügbare Sprachen

Service Parts

Indoor air ﬁ lter

1. Remove any dust adhering to the ﬁ lter by using a vacuum cleaner or wash in lukewarm water

2. Rinse the ﬁ lter well and dry before placing it back onto the unit.

3. Do not use gasoline, volatile substances or chemicals to clean the ﬁ lter.

Indoor unit

1. Clean any dirt or dust on the grille or panel by wiping it with a soft cloth soaked in lukewarm

2. Do not use gasoline, volatile substances or chemicals to clean the indoor unit.

• Avoid direct contact of any coil treatment cleaners on plastic part. This may cause plastic part to deform as a result

of chemical reaction.

1. Open the front panel.

• Hold the panel at the recesses on the main unit (2 recesses

on right and left sides) and lift it until it stops.

2. Remove the front panel.

• While lifting the front panel further, slide it to the right

and pull it to the front side. The left rotating shaft is

detached. Slide the right rotating shaft to the left and

pull it to the front side to remove it.

3. Attach the front panel.

• Align the right and left rotating shafts of the front panel

with the grooves and push them all the way in.

• Gently close the front panel. (Push both ends and the

center on the front panel.)

• Don't touch the metal parts of the indoor unit. It may cause an injury.

• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.

• For cleansing, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing

compound, scrubbing brushes, nor other hand stuff.

• After cleaning, make sure that the front panel is securely ﬁ xed.