Installation Diagram; Installation Of The Outdoor Unit - Daikin J serie Installationshandbuch

Indoor unit
Front panel
50mm or more from walls
(on both sides)
The outdoor unit must be installed in such a way, so as to
prevent short circuit of the hot discharged air or obstruction to
the smooth air fl ow. Please follow the installation clearances
shown in the fi gure. Select the coolest possible place where
intake air temperature is not greater than the outside air
temperature (please refer operating range).
Installation clearances
Dimension
Minimum Distance, mm
Note: If there is any obstacle higher than 2m, or if there is any
obstruction at the upper part of the unit, please allow more
space than the fi gure indicated in the above table.

INSTALLATION DIAGRAM

30mm or more from ceiling
M4 x 12L
n Opening service lid
Air filter
Service lid is opening/closing
type.
n Opening method
1) Remove the service lid
2) Pull out the service lid
3) Pull down.
Outdoor Unit

INSTALLATION OF THE OUTDOOR UNIT

A B C
300 1000 300
Caulk pipe hole
gap with putty.
Service lid
screws.
diagonally down in the
direction of the arrow.
D
500
C
1-6
Cut thermal insulation pipe
to an appropriate length and
wrap it with tape, making
sure that no gap is left in the
insulation pipe's cut line.
Wrap the insulation pipe with the
finishing tape from bottom to top.
A B
D