System Configuration (Configure); Setting The Time (Time Setup) - Silvercrest SFB 10.1 C3 Bedienungsanleitung

3. Press
4. Then press the device button
program and press
5. The first digit of the 4-digit device code currently set flashes.
6. Enter the correct 4-digit code for the selected device using the
number buttons, then enter the number of the corresponding code list
(0 to 7) and press
7. Press
followed by "CODE SET".
8. Invalid CODES cannot be found in the CODE list. If you enter an
invalid code "NOT FOUND" appears on the display and you can
then enter the correct code.
Press to go back one menu level. To return to the start window,
press one of the device buttons. On the left of the time the code assigned
to the device button
selected code list (0 to 7) is also displayed to the left of the day of the
week.
Before you can program the device buttons
brand code search or automatic search, it is necessary to assign the code
list to the device button. To do so, proceed as described in the previous
section, select the number 0001 as your code and select the number of
the desired code list (0 to 7). This assigns the code list to the device
button
At this point, programming the device buttons
the same way as described in the "Automatic code search (AUTO
SRCH)" and "Brand code search (BRAND SRCH)" chapters.

System configuration (CONFIGURE)

Setting the time (TIME SETUP)

1. Press and hold the
2. Press
3. Press
4. Press
5. Press
6. Press
can also adjust the value by using the numeric keypad (11).
7. Press
8. Press
can also adjust the value by using the numeric keypad (11).
9. If you selected "12HR" in step 4, you can press
PM/AM setting. Press
AM.
10. Press
reads "SUCCESS" followed by "TIME SETUP".
Press to go back one menu level. To return to the start window,
press one of the device buttons.
, select "CODE SET" and press
to confirm.
to confirm.
to confirm the entry. The display reads "SUCCESS"
or so you can proceed with programming.
, select "CONFIGURE" and press
, select "TIME SETUP" and press
, select between "12HR" and "24HR".
to toggle to time setting mode. The hour display flashes.
and select the correct value for the hour. You
to toggle to minute setting mode.
and select the correct value for the minutes. You
to confirm your entry and save the setting. The display
or
or is shown on the display. The
button for 3 seconds.
to toggle between PM and
SilverCrest SFB 10.1 C3
to confirm.
that you wish to
or
or
to confirm.
to confirm.
to select the
English - 101
using the
works