Automatic Code Search (Auto Srch) - Silvercrest SFB 10.1 C3 Bedienungsanleitung

characters for a brand name. If you make a mistake, press
delete the last character and enter it again.
7. Typically, different device manufacturers use different codes for their
remote controls. At this point you'll have to find the optimum code.
The current code is shown under the selected brand name. You can
press the
brand.
8. Now test the code selected by pointing the remote control at the
device and checking if it responds properly to the button pressed . It
is not necessary to exit the setup mode to perform this test.
The following buttons cannot be used for the function test:


the device buttons (4)

the numeric keypad (11)
9. If most of the buttons work properly, press
the device button selected .
10. If no buttons work properly or only a few do, press
next code and repeat the test as described in step 8. Repeat this
procedure as many times as necessary until you have found suitable
code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Repeat the above procedure for all devices you wish to control with your
new remote control.

Automatic code search (AUTO SRCH)

1. Press and hold the
2. Press
3. Press the device button for the device you wish to program. Then
press . The remote control starts sending all available codes. This
is indicated by a flashing
By default the remote control sends the code for the
If no code is assigned to the
send for the different devices:

TV:
the remote control sends the code "CH+".

DVD/CD/VCR:
the remote control sends the code "PLAY".

DSAT/CBL:
the remote control sends the code "CH+".

AMP:
the remote control sends the code "MUTE".

Other devices:
the remote control sends the code "CH+".
4. If your device responds to the sent code by powering on or off or by
executing one of the above functions, press
search. At this point you are close to the correct code, but you may
not yet have found the one that matches completely, as the
buttons to select the preset codes for the desired
,
, select "CODE SETUP" and then press
and select "AUTO SRCH". Press
, ,
button for 3 seconds.
IR icon on the display.
button, the following codes will be
SilverCrest SFB 10.1 C3
. The code is saved for
to select the
.
button.
to stop the
English - 99
to
. Press