Direct Code Input (Code Set); Flex Mode - Silvercrest SFB 10.1 C3 Bedienungsanleitung

SilverCrest SFB 10.1 C3
automatic search had been stopped with a slight delay and further
codes have been sent.
During the automatic search, the remote control responds to the
and buttons only.
5. After you have pressed the
press the
manually. If your device responds again to a code, you have found
a suitable code. Press
are saved and the display reads "SUCCESS".
6. Or press
codes.
7. After the remote control has finished transmitting the last available
code from the code list, the search will stop and after a few seconds
the start window appears.
Press to go back one menu level. To return to the start window,
press one of the device buttons.

Direct code input (CODE SET)

1. Press and hold the
2. Press
3. Press
The selected device flashes and the currently set device code
appears on the display. At this point you can select a different device
by using the device buttons. Confirm your selection with
4. The first digit of the 4-digit device code currently set flashes.
5. Enter the correct 4-digit code for the device selected by using the
number buttons. You can find the 4-digit code in the device code list
supplied.
6. Press
followed by "CODE SET".
7. Invalid CODES cannot be found in the CODE list. If you enter an
invalid code "NOT FOUND" appears on the display and you can
then enter the correct code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.

Flex mode

For the different device buttons there are preset code lists for specific
device groups. Normally, you will assign the corresponding device types
to the device buttons. For example, you will assign programming a VCR
to the
etc. Furthermore, the Flex mode conveniently lets you assign a device
from any device group to the
that you assign the code list of the desired device group (where the
device belongs to) to the
this device.
The code lists (e.g. 0 for TV or 2 for DVD) belonging to each device
group can be found in the table below:
TV VCR
0 1
For direct code input:
1. Press and hold the
2. Press
confirm.
100 - English
to exit the automatic search. This will not save any
, select "CODE SETUP" and then press
, select "CODE SET" and press
to confirm the entry. The display reads "SUCCESS"
device button, a DVD player to the
DVD DSAT
2
, select "CODE SETUP" and press
button to stop searching you can
buttons to send the previous or next codes
to exit the automatic search. The codes
button for 3 seconds.
and
or
BD
3 4
button for 3 seconds.
device button,
buttons. The requisite is
button you want to use for
AMP CBL
5 6
.
to confirm.
.
CD
7
to