Service And Customer Care - Kenwood HM400 Serie Handbuch

4 Place the food to be mixed into the
bowl, and then place the bowl onto
the mixer stand.
5 Press the release/locking button and
at the same time lower the mixer.
6 Plug the mixer into the power supply.
7 Operate the mixer by moving the 5
speed control switch to the
appropriate mixing speed. As you
push the button forward, the speed
will increase (the speeds are
indicated by markings adjacent to
▼ ▼
the ).
●
Remember as you increase the
speed you automatically increase the
power. As the mixture becomes
heavier, increase the power by
turning to a higher speed. If the
machine starts to labour on a low
speed turn to a higher speed.
●
On some occasions depending upon
the quantity and consistency of the
mixture in the bowl, some assistance
may be required to help the bowl
revolve. Generally the bowl will
rotate clockwise, but certain
mixtures may cause an anticlockwise
rotation.
●
It is important to note that when
using the mixer on the stand, it will
be necessary to scrape down the
sides and across the bottom of the
bowl at regular intervals to assist
with the mixing operation.
8 After use switch off and disconnect
the mixer from the power supply.
9 To eject the beater/kneaders push in
the release/locking button and raise
the mixer upwards. Hold the
beater/kneader shafts whilst
pressing the eject button.
Note: If you wish to mix larger
quantities and heavier mixes it is
recommended that the mixer be
removed from the stand and held in
a suitably sized container.
cleaning
●
Always switch off, unplug and
remove the beaters or kneaders
before cleaning.
●
Never put the mixer body in water or
let the cord or plug get wet.
●
Never use abrasives to clean parts.
beaters, kneaders
●
Wash by hand or in your dishwasher,
then dry.
mixer body and stand
●
Wipe with a dry to slightly damp
cloth then dry.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
●
using your mixer or
●
servicing or repairs
Contact the shop where you bought
your mixer.
●
Designed and engineered by
Kenwood in the UK.
●
Made in China.
3