Parkside Performance HG02735 Handbuch Seite 12

˜ Additional instructions for
installing attachments
The locking flange 8 is usable on both sides and
must be mounted according to the thickness of the
attachment. For use with thin attachments, the collar
faces up. For use with thick attachments, the collar faces
down. The attachment must be securely fastened to the
power tool.
˜ Operation
˜ Abrasive cutting
WARNING!
Never use grinding disks for cutting! When using
a cutting disk, a protective cover suitable for the
attachment must be used when operating the power
tool.
1. Only use tested, fiber reinforced cutting or grinding
disks.
2. Always work at a low forward speed. Apply only
moderate pressure to the workpiece.
3. Always use up (conventional) milling. This will
prevent loss of the power tool when it leaves the
cut.
12 GB/IE/NI/MT/CY