Assembling The Grass Catcher Box; Mono Handlebar (Me 443 C); Folding Down The Handlebar; Dual Handlebar (Me 443) - Viking ME 443 Gebrauchsanleitung

7.4 Assembling the grass
catcher box
● Fit the upper part of the grass
catcher box (B) onto the lower part of
the grass catcher box (C). Ensure
correct location in the guides.
● Push pin (D) through the bores
provided from inside.
● Allow the upper part of the grass
catcher box (B) to engage in the lower
part of the grass catcher box using
slight pressure.
● Attach the grass catcher box (
8. Controls

8.1 Mono handlebar (ME 443 C)

The lawn mower ME 443 C is
equipped with an adjustable mono
handlebar.
Danger of electric shock!
The electric cable must always be
attached to the quick-release clamp
body and the handlebar console.
Danger of pinching!
Before actuating the detent
lever (1), hold the upper
handlebar (2) with one hand at its
highest point and lift (relieve load)
slightly.
After actuation of the detent lever,
the upper handlebar can fall to the
lowest position under its own
weight.
Never place your finger between
the handlebar and the handlebar
console (under the detent lever).
38

1 Folding down the handlebar:

Transport position (for cleaning, for
5 space-saving transport and for storage of
the machine):
● Press the detent lever (1) downwards
and hold.
● Fold the handlebar (2) down forwards,
ensuring that the electric cable is not
damaged.
Working position (to push machine):
● Fold the handlebar (2) up rearwards
and ensure that the handlebar is fully
8.3).
engaged.
2 Height adjustment:
The height of the mono handlebar can be
adjusted to 2 levels:
● Press the detent lever (1) downwards
and hold.
6
● Move the handlebar (2) into the
required position.
● Release the detent lever (1) and ensure
that the handlebar is again fully
engaged.

8.2 Dual handlebar (ME 443)

Danger of pinching!
The upper handlebar can be folded
down by releasing the quick release
caps. For this reason, always hold
the upper handlebar (2) with one
hand at its highest point when you
open the quick-release caps.
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Open the quick-clamping devices (1) –
fold downwards – and fold the upper
handlebar (2) forwards, ensuring that
the electric cable is not damaged.
Working position (to push machine):
● Fold up the upper handlebar (2)
rearwards and hold with one hand.
● Close the quick-clamping devices (1) –
fold upwards.

8.3 Grass catcher box

Attaching:
● Open the discharge flap (1) and
hold it open.
● Attach the grass catcher box (2) to the
mountings (3) on the rear of machine by
means of the locating lugs.
● Close the discharge flap (1).
Detaching:
● Open the discharge flap (1) and hold it
open.
● Lift the grass catcher box (2) and
remove it rearwards.
● Close the discharge flap (1).
7
8.4 Central cutting height
adjustment
Six different cutting heights can be
set.
Level 1 = 25 mm
8
9
0478 121 9920 D - EN