Maintenance; Troubleshooting - Makita BTD132 Bedienungsanleitung

The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3. Bolt
Even though the torque coefficient and the
•
class of bolt are the same, the proper
fastening torque will differ according to the
diameter of bolt.
Even though the diameters of bolts are the
•
same, the proper fastening torque will differ
according to the torque coefficient, the class of
bolt and the bolt length.
Trouble
The tool stops
during operation.
009217
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
Light status
Flickers twice per
second.
Flickers three times per
second.
(LED indicator for
empty signal for
remaining battery
capacity also flickers.)
Flickers five times per
second.
Flickers once
per second.
Not flickers
or attachments
Only use accessory or
4. The manner of holding the tool or the material of
driving position to be fastened will affect the
torque.
5. Operating the tool at low speed will cause a
reduction in the fastening torque.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance except for the
following troubleshooting related to the light.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Troubleshooting

Steps to be taken
The tool temperature is high.Cool down it fully.
The tool restarts after its temperature becomes low.
Remaining battery capacity level is low. Charge the
battery cartridge.When the LED indicator still flickers
even after charging the battery cartridge, stop using
and have the tool repaired by a Makita local service
center.
Use the tool with the motor not locked.If the motor
remains locked, stop using and have the tool
repaired by a Makita local service center.
Stop using and have the tool repaired by a Makita
local service center.
The tool stops when continuing to pull the switch
trigger for more than approximately 2 minutes.
Release the switch trigger.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Screw bits
•
Hook
•
Plastic carrying case
•
Various type of Makita genuine batteries and
•
chargers
are
8