Attachments On Request; Mulching" Kit; Battery Charger - Stiga MCS 470 Li D48 Serie Gebrauchsanweisung

12. The display shows
ER2+ ER3 alternate-
ly (Fig.36.B) (type
"II"/"III" handle - Ad-
vanced Series).
13. Mowing is difficult.
14. Excessive noise and/
or vibration is experi-
enced whilst working.
15. Battery power re-
serve is low.
16. The battery charger is
not charging the battery.

15. ATTACHMENTS ON REQUEST

15.1

"MULCHING" KIT

Finely chops the cut grass and leaves it on
the lawn, instead of collecting it in the grass
catcher (for machines equipped with it).
15.2 BATTERIES
Different capacity batteries are available to
suit specific operating requirements (Fig.37.0).
The list of approved batteries for this machine
is found in the "Technical Data" table.
15.3

BATTERY CHARGER

Device used to recharge the battery (Fig.38.0).
Motor anomaly.
The cutting means is not
in good condition
Cutting means fittings are loose or
the cutting means is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
Remove the safety key and contact your
Dealer or the Authorised Service Centre
for checks, replacements or repairs.
Contact the Authorised Service
Centre for the sharpening or
replacement of the cutting means.
Immediately turn off the motor
and remove the safety key.
Contact the Authorised Service Centre for
checks, replacements or repairs (par. 8.1).
Optimise operations (par. 7.2.1).
Use a second battery or extended
battery (par. 15.2).
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
EN - 15