Operating The Pda Detector 2800; Function Of Foil Key And Leds; Installation Of The Smartline Pda Detector 2800 - Knauer Smartline 2800 Benutzerhandbuch

Operating the PDA Detector 2800

Operating the PDA Detector 2800

Function of Foil Key and LEDs

Standby key
I
I
Power LED
Busy LED
Error LED
UV LED
VIS LED

Installation of the Smartline PDA Detector 2800

PC Specifications
In the case that a Smartline RI Detector should also be arranged in the
tower, the RI detector should be installed below the PDA detector due to
it's higher sensitivity to temperature.
The keypadFehler! Verweisquelle konnte nicht gefunden werden.
consists of a standby key with LED and five separate LEDs.
Pressing the standby key for more than two seconds switches the
instrument off (only the standby electronics will still be working). In
standby mode the red LED integrated into the standby key is on. To
switch the instrument on again the standby key has to be pressed for
more than one second. Then the instrument powers up again and the red
LED is off.
The Power LED lights when the instrument is switched on (main power
switch or standby key if switched off with standby key).
The Busy LED begins to light at low intensity when the connection
between detector and PC is established (e.g. when a method is started ).
The BUSY LED lights at high intensity when data is tranfered by the
detector.
The Error LED lights when the instrument is switched on (main power
switch or standby key if switched off with standby key) and is switched of
as soon as a connection between detector and PC is established (e.g.
when a method is started). The Error LED lights up again when an
internal error occurred.
The UV LED begins to light about 30 seconds after the connection
between detector and PC is established (e.g. when a method is started).
If the detector is equipped with a halogen lamp the VIS LED begins to
light when the connection between detector and PC is established (e.g.
when a method is started).
•
Pentium III or higher
9