Fitting The Back To The Chair - Sunrise Medical Jay J3 Bedienungsanleitung

EngLIsh
E n gL I s h
deTermInIng compaTIBIlITy
Wheelchair types
The J3 Back is designed to be compatible with most wheel-
chairs with the following exceptions:
Wheelchairs that are angularly adjustable, recline or tilt and
result in a back angle greater than 60 degrees from the verti-
cal should not be used.
WarnIng
use with these types of wheelchairs may cause the
back to accidentally disconnect from the wheelchair
resulting in a fall and the potential for serious injury.
Wheelchair Dimensions
The J3 Back is designed to replace the wheelchair's sling
upholstery. Prior to installation determine if the wheelchair
used has compatible back canes, by measuring the width
between your back canes as seen in Figure 1. Then using
that measurement, check Table 1 to determine if the back will
fit your chair.
Next check that the back canes are a compatible diam-
eter. The J3 back hardware can be mounted on wheelchair
back canes ranging from 3/4" (1.9 cm) to 1 1/8" (2.85 cm).
Measure your back cane diameter (Fig. 2) and refer to Table
2 to ensure your back canes are compatible.
If you cannot determine that the back canes are compatible
please contact your authorized Sunrise Medical provider
or Sunrise Medical customer service.
106109 Rev. D
FIT TING TH E B acK TO TH E c H aIR
a
J3 Back Width* Width of back canes from outside to
(all contours) outside of the tubes, (Fig.1-a)
Minimum Width
inch
12" 31cm
11.7
14" 36cm
13.7
16" 41cm
15.7
18" 46cm
17.7
20" 51cm
19.7
* Back Width is identified in your back's part number.
Example: J3ScMTS36 is a 36 cm back.
cane diameter (Fig. 2-B)
J3 Back Width
Minimum width
(all contours)
inch
14-20" (36-51cm) 3/4
6
J 3 Bac K
Figure 1
a
table 1
Maximum Width
cm inch cm
29.7 14.3 36.3
34.9 16.3 41.3
40.0 18.3 46.4
45.1 20.3 51.6
50.1 22.3 56.5
Figure 2
B
table 2
Maximum width
cm inch cm
1.9 1 1/8 2.85