Accessing A Parameter; Changing A Parameter Value - Siemens SITRANS Probe LU Kurzanleitung

Accessing a parameter

Note:
• The following instructions apply when using the Hand Programmer.
• Do not use the Hand Programmer at the same time as SIMATIC PDM, or erratic
operation may result.
• You do not need to key in initial zeros when entering a parameter number: for
example, for P005, key in 5.
1. Press PROGRAM
activate PROGRAM mode.
2. Either use the ARROW keys
a different parameter, or
3. Press DISPLAY
Number field.
4. Key in the desired parameter number followed by
ENTER .
For example: press
The LCD displays the new parameter number and
value.

Changing a Parameter Value

Notes:
• Security must be disabled to enable programming: set P000 to the Unlocked Value
stored in P069. (For more details, see
• Invalid entries will be rejected or limited.
• CLEAR can be used to clear the field
1. Use the ARROW keys
DISPLAY
2. Key in the new value.
3. Press ENTER
Parameter Reset to Factory Default
1. Scroll to the parameter or enter its address.
2. Press CLEAR
Page 18 SITRANS Probe LU – INSTRUCTION MANUAL
then DISPLAY
to open the Parameter
.
to scroll to the parameter number, or press
and key in the parameter number followed by ENTER
to set the value.
then ENTER . The value returns to the default setting.
to
to scroll to
P069 Unlocked value
on page 39.)
PROGRAM Icon
Parameter Number
Parameter Value
current value
.
7ML19985HT01