Changing Parameter Settings - Siemens SITRANS LR 200 Kurzanleitung

Network Address
Verifying/changing the device address via the hand programmer (default 126)
Notes:
• Local programming must be enabled, to allow changes (see
page 10).
• CLEAR can be used to clear the field.
C
• Press Right ARROW
• Press Left ARROW
icon is not visible).
1. Press Mode
open Menu level 1.
2. Press Right ARROW
Address.
3. Press Right ARROW
PROGRAM icon will flash.
4. Key in a new value and press Right ARROW
accept it. (The LCD displays the new value; PROGRAM
icon disappears, and the last menu digit flashes to
indicate Navigation mode.)
5. Press Mode
Performing calibration via PROFIBUS PA
To configure SITRANS LR 200 (PROFIBUS PA) over the network, you will need a PC
configuration tool: we recommend SIMATIC PDM. Please consult the operating instructions or
online help for details on using SIMATIC PDM. (An Application Guide
instruments and SIMATIC PDM
https://pia.khe.siemens.com/index.asp?Nr=7427.)

Changing parameter settings

• First launch SIMATIC PDM, connect to SITRANS LR 200 (PROFIBUS PA), and upload
data from the device.
• Adjust parameter values in the parameter view field (right side of screen).
• After adjusting the value, press Enter (the status fields read Changed).
• When you have completed the adjustments, open the Device menu, download data
to the device, and save parameter settings offline (the status fields go blank).
7ML19985QG81 SITRANS LR 200 (PROFIBUS PA) – QUICK START MANUAL
to open Edit mode: the PROGRAM icon flashes.
to cancel Edit mode: the Menu number flashes (the PROGRAM
to activate PROGRAM mode and
twice to navigate to Device
again to open Edit mode: the
to return to RUN mode.
is available on our website at:
Local operation enable
Menu level: last
digit flashes in
Navigation mode.
Program icon:
flashes in Edit
mode.
to
Right-most digit
flashes in
Navigation
mode.
SMPI PROFIBUS PA
on
Page EN-11