Miomare IAN 315297 Montage-, Bedienungs- Und Sicherheitshinweise Seite 11

Tighten the cartridge retaining ring
tap body again by using a pipe wrench. Then,
14
tighten the cartridge covering ring
Place the control lever
body . Tighten the locking screw
14
ing it clockwise using the Hexagonal key.
Press the red / blue hot / cold label
opening.
Turn on the main water supply and check the
temperature limiter.
Water-saving function
The cartridge in this tap has an Eco-Click
13
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. G).
Lift the lever until you notice a slight resist-
8
ance. This resistance will cause a stop in case
of partial opening and will therefore simply limit
the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
resistance.
Energy-saving function
The cartridge in this tap has an energy
13
saving function.
Only cold water will flow out when the control
lever is set to the middle position, and thus
8
reduce energy comsumption (see fig. H).
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
onto the
12
by hand.
11
back on to the tap
8
by turn-
9
into the
10
until you overcome the
8
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
applies particularly as far as babies and infants
are concerned. Failure to observe this advice
may result in risks to health. Fresh water can
be readily distinguished from stagnant as fresh
water is noticeably cooler.
Do not use stagnant water from chromium-plated
pipework for the preparation of food or for drink-
ing or for personal hygiene if you are allergic
to nickel. This water may contain high quantities
of nickel and trigger an allergic reaction.
at regular intervals
7
GB/IE 11