Operating Elements; Start-Up; Boiling Water - Silvercrest KH 1023 Bedienungsanleitung

Operating Elements

q
Handle
w
Lid with knob
e
Scale
r ON/OFF switch with integrated
pilot light
t
Base
y
Pourer sieve

Start-up

Important
Always and only use freshly drawn mains water in
the kettle! Do not consume any water that is not
certified as potable. If you do, you are taking a risk
with your health!
• Before taking the appliance into use, ensure that ...
• the appliance, the plug and the power cable are
in good working order and...
– the power cable been completely unwound from
the holder on the bottom of the appliance, and
that...
– all packaging materials have been removed
from the appliance.
• Fill the appliance with water up to the MAX
mark and let it come to a full boil once – as
described in the next section.
• Pour this water away after the water has been
boiled.
• Rinse the water boiler out with clear water.
• Fill the appliance with water once again up to the
MAX marking on the scale
to the boil. When done, pour this water away
also.
The appliance is now ready for use.
e
and then bring it
- 3 -

Boiling water

Danger
Never place the electrical base
– a potentially fatal risk!
• Lift the kettle off of the base when filling it!
w
• Remove the lid in that you pull it upwards.
• Hold the kettle upright while filling it. Only in this
way can you correctly read the markings on the
scale e .
Fill the kettle ...
– at least to the MIN mark, so that the device does
not overheat,
– no higher than the MAX mark, so that no boiling
water spills out.
• First close the lid w
• and then place the kettle on the base
that it is standing absolutely upright on the base
• Now insert the plug into the mains power socket ...
• and press the ON/OFF switch
until it engages.
• The pilot lamp integrated into the ON/OFF
r
switch indicates that the appliance is now
heating the water up.
• The appliance switches itself off and the pilot
lamp goes out as soon as the water is on the
boil. The ON/OFF switch
Warning
Remove the plug from the mains power socket before
you lift the kettle from its base
a potential short circuit by water possibly spilling
out of the carafe and falling onto live electrical
connections in the base
Injury hazard
For safety reasons, the lid
while the water is boiling or is very hot.
There is a risk of receiving severe scalds.
t
adjacent to water
...
t
r downwards
r springs upwards.
t . This prevents causing
t
.
w should not be opened
such
t
.