Before Getting Started - hanseatic HFD18560A1WDI Gebrauchsanleitung

Page EN-32 Start-up
Parts required:
Included in the package contents:
(36) 2× wall brackets
(37) 1× water filter
(39) 4× safety clips (red)
(40) 2× safety clips (blue)
(41) 1× hose, 5 m
(42) 1× hose coupling
(43) 2 screws, ST4.2*16
(44) 1× check valve
**Not included in the package contents
(45) 2 wall plugs
You will require a tap with a ¾-inch screw
connector for the water supply.

Before getting started

To mount the water filter (37) on a wall, you
will need the following tools (not included in
package contents):
– Drill
– Cross-head screwdriver
– Measuring stick
– Level
– Pencil
Installation must only occur on a suit-
able, non-hollow (solid) wall. Special
wall plugs or anchors may be necessary for
drywall. Consult with an expert.
Install the water filter in an easily accessible
location so you can replace it if required.
Attaching the water filter
(43)
1. Use the screws (36) to attach the water
filter's wall brackets (43) to the wall in or-
der for the water filter to hang vertically in
the bracket.
(37)
2. Remove the protection caps (47) from
both ends of the water filter (37).
3. Put the water filter (37) in the wall brack-
ets (36) so that there is an upward direc-
tional flow.
(36)
(47)
(36)
(47)