Herunterladen Inhalt Inhalt Diese Seite drucken

Using As A Charger (Recharge Of Internal Batteries); Internal Batteries : Advices And Maintenance - GYS Startpack 12.24 Betriebsanleitung

Vorschau ausblenden Andere Handbücher für Startpack 12.24:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
U
SAGE AS A CHARGER
In order to have your Startpack fully operational and to ensure maximum output power, it is advised
to charge it after each use, and leave it charging until its' next use.
Startpack includes a high quality automatic charger, which will recharge its 2 batteries to a 100%
charge, monitoring is not necessary and a maximum charge will be maintained due to the advanced
charging cycle (Floating System).
• • • • After every use, près utilisation, turn the battery switch on OFF and disconnect
the clamps from the vehicle.
• • • • Connect the charger to a 230V 50/60Hz socket
• • • • Switch the button on 12V mode
WARNING: If you do not plug the 12V socket, the charge process won't start
The product will show you the charge status :
- Orange light: charging – voltage increasing
- Flashing Orange light: voltage regulation (2h to 16h if batteries are sulphated
or deeply discharged)
- Green light : the battery is charged + floating
• • • • After the charge, you can leave the machine connected to the socket
Avant toute manutention, positionnez-le commutateur sur OFF
I
B
NTERNAL
ATTERIES
These high performance batteries require particular care. Following these instructions will prolong
their effective life to the maximum.
Charge the STARTPACK initially after purchase and then after each use.
Do not use an external charger. Only use the one integrated in the STARTPACK.
Turn the battery-switch OFF during the charge, and disconnect the voltage selector to prevent any
error after a recharge.
Never short circuit the clamps when the battery-switch is turned ON.
Never connect the red clamp on the (-) of the vehicle battery, and the red clamp on the ground of
the engine. This would result in a short circuit.
Wait 3 minutes between each starting attempt. This allows the batteries voltage to rise again, and
the internal elements to cool down. If you do not wait and/or if any starting attempt lasts for too
long, you risk losing some power, and you reduce your chances of succeeding the start on next
attempts.
(
RECHARGE OF INTERNAL BATTERIES
:
ADVICE AND MAINTENANCE
)
8

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis