Connections And Controls - Lightmaxx Nano Truss Light Mobile Bedienungsanleitung

Charge Status:
The charge level is indicated by green and red LEDs on the back of the device.
If all four LEDs are green, the battery is fully charged. If only one green LED lights up, the
battery is soon exhausted and must be recharged. The device can be used in this condition can
still be operated for a few minutes. It then switches itself off due to the protection circuit against
deep discharge.

Connections and controls:

No. Designation
1 LEDs
2 Control Display screen
3 Internal built-in microphone
4 Menu button
5 UP Button
6 Down Button
7 Enter Button
8 IR remote control sensor
9 Safety chain anchor point
No. Designation
10 IEC Mains Input
11 IEC Power Link Output
12 Battery ON/OFF Button
13 Power On/OFF Button
14 Battery level indicators
15 Threaded mounting points
16 DMX Input (3-pol)
17 DMX Output (3-pol)
ENGLISH