General Description; Scope Of Delivery; Function Description; Summary - Silvercrest PSS 65 A1 Originalbetriebsanleitung

General description

The illustrations can be found
on the front and rear fold-out
pages.

Scope of delivery

Unpack the equipment and check that it is
complete. Dispose of the packaging mate-
rial correctly.
• Appliance
• Sharpener for
knives and scissors
• Sharpener for drills
• Sharpener for picks and chisels
• Spare grinding wheel
• Translation of the original instructions
for use

Function description

The sharpening station is suitable for
sharpening tools (e.g. drills, knives, scis-
sors, picks, chisels). The scope of delivery
contains three sharpeners for this purpose,
which, as a guide and safety device, en-
able precise sharpening and grinding.
Refer to the following descriptions for a
functional description of the controls.

Summary

1 Mains plug
2 Sharpener for knives and
scissors
3 On/off switch
4 Spacer
5 Magnet holder
6 Tool table
7 Retaining screw for
angular adjustment
8 Protective hood
9 Mounting holes for
work bench assembly
10 Grinding disc
11 rotatable drill mount
12 Knurled nut for drill-fastening
13 Release lever for
sharpener
14 Drill holder
15 Adjusting device
16 Grinding wheel nuts

Technical specifications

Nominal input voltage
............................. 220 - 240 V~, 50 Hz
Power consumption ...................... 65 W
Measurement idling speed
Safety class .....................................
Protection category......................... IP 20
Weight ................................ ca. 1,25 kg
Grinding angle range ................15° - 50°
Sharpness drill diameter ............ 3 -10 mm
Sharpness knife width .............. 6 - 51 mm
Sound pressure level
(L ) ............. 59,3 dB (A); K
pA
Sound power level (L
measured ........73,5 dB(A); K
* A break is introduced after 10 minutes of
uninterrupted operating duration until the
device temperature differs 2 K (2°C) less than
room temperature.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further develop-
ment without notice. All dimensions, refer-
ences and information in this instruction
manual are therefore not guaranteed. Legal
claims made on the basis of the instruction
GB
(S2 10 min)*
n ... 6700 min
0
= 3 dB (A)
pA
)
wA
= 3 dB(A)
wA
IE
-1
II
5