TaHoma®
- When the TaHoma® unit has recognised all of the sensors,
click "Continue".
- If the RTS option has not been checked, click the "My
house" tab and then go to the "Configuring the house"
section.
7.4. Detecting Rts end products
If the "RTS" option has been checked, a new window opens
to add RTS end products:
- Click "Add".
- TaHoma® asks you to select the end product's control
mode:
• Three-button remote control:
• One-button remote control: sequential control.
- Once you have selected the control mode, click "Continue".
- Click "Continue" to add the RTS end product.
- Press the PROG button on the RTS remote control until
the end product moves back and forth (≈ 2 seconds).
- Then click "Continue".
- Click "Identify" so that the TaHoma® unit identifies itself to
the RTS end product. The end product will move back and
forth again; TaHoma® is then paired with the RTS motor
or receiver.
- Click "Continue" to move on to the next step.
8
/
control.
Copyright © 2010-2011 Somfy SAS. All rights reserved.