Detecting Io-Homecontrol® Sensors - SOMFY TaHoma Installationsanleitung

- After you have clicked "Restart", at the end of the search
phase, a new screen appears.
You can then add, delete, rename or identify an end
product by clicking the corresponding button.
- When the TaHoma® unit has recognised all of the
io-homecontrol® end products, click the "Continue" button.
7.3. Detecting io-homecontrol® sensors
- Once you have finished detecting the io-homecontrol®
end products, if the installation includes io-homecontrol®
sensors, click "Continue". If not, click "Cancel" and go
directly to the "Detecting RTS end products" section.
- Click "Continue" again to add an io-homecontrol® sensor.
- Press the PROG button on the io-homecontrol® sensor
until the green indicator light comes on (≈ 2 seconds).
- Then click "Continue".
- The TaHoma® unit searches for the sensor.
- Enter the sensor name so that you can identify it
subsequently, and click Apply.
- Repeat the procedure to add more io-homecontrol®
sensors.
You can then add, delete or rename an io-homecontrol®
sensor by clicking the corresponding button.
Copyright © 2010-2011 Somfy SAS. All rights reserved.
TaHoma®
7