Wrap Piping And Cables - Kaisai ONE Serie Bedienungsanleitung

NOTE ABOUT WIRING
THE WIRING CONNECTION PROCESS MAY
DIFFER SLIGHTLY BETWEEN UNITS AND
REGIONS.
Step 7: Wrappiping and cables
Before passing the piping, drain hose, and the
signal cable through the wall hole, you must
bundle them together to save space, protect
them, and insulate them(Not applicable in
North America).
Bundle the drain hose, refrigerant pipes, and
1.
signal cable as shown below:
Indoor Unit
Drain hose
Signal wire
DRAIN HOSE MUST BE ON BOTTOM
Make sure that the drain hose is at the bottom
of the bundle. Putting the drain hose at the
top of the bundle can cause the drain pan
to overflow, which can lead to fire or water
damage.
DO NOT INTERTWINE SIGNAL CABLE WITH
OTHER WIRES
While bundling these items together, do not
intertwine or cross the signal cable with any
other wiring.
2. Using adhesive vinyl tape, attach the drain
hose to the underside of the refrigerant pipes.
Using insulation tape, wrap the signal wire,
3.
refrigerant pipes, and drain hose tightly
together. Double-check that all items are
bundled.
DO NOT WRAP ENDS OF PIPING
When wrapping the bundle, keep the ends
of the piping unwrapped. You need to access
them to test for leaks at the end of the
installation process (refer to Electrical Checks
1.
2. Otherwise, double-check that the ends of the
3. Slowly pass the wrapped bundle of refrigerant
4. Hook the top of the indoor unit on the upper
5. Check that unit is hooked firmly on mounting
Space behind unit
6.
Refrigerant piping
Insulation tape
7. Again, check that the unit is firmly mounted
82
Step 8: Mount indoor unit
If you installed new connective piping to the
outdoor unit, do the following:
If you have already passed the refrigerant
piping through the hole in the wall, proceed
to Step 4.
refrigerant pipes are sealed to prevent dirt or
foreign materials from entering the pipes.
pipes, drain hose, and signal wire through the
hole in the wall.
hook of the mounting plate.
by applying slight pressure to the left and
right-hand sides of the unit. The unit should
not jiggle or shift.
Using even pressure, push down on the
bottom half of the unit. Keep pushing down
until the unit snaps onto the hooks along the
bottom of the mounting plate.
by applying slight pressure to the left and the
right-hand sides of the unit.