Werbung
Connection Configurations
Connection C – Electrical
Figure 22
The turbopump is connected to the controller through an 6-pin
connector. Pins B, C and D are the 3-phase supply to the motor, pins
A and F are connected to the temperature sensor (NTC type, 30 KΩ
resistance at 25 °C) and pin E is connected to the pump ground.
If the temperature sensor is disconnected, the pump will not start. To
prevent damage to the pump when the temperature exceeds 60 °C,
the sensor automatically cuts out the power supply.
TV 301-P Navigator Controller User Manual / 87-901-001-01 (B)
Connection C
Technical Information
Connection Configurations
17
217/224
Werbung
Kapitel
