Technical Information - Electrolux EQT4520BOG Benutzerinformation

78 www.electrolux.com

TECHNICAL INFORMATION

Serie EQT4520BOG
Typ 55 TEP 02 AO
Induction 1.8 kW
Ser.Nr. ..........
Electrolux
5. Put the first appliance in the worktop
cut out. Put the connection bar in the
worktop cut out and push up half of
the width against the appliance.
6. Loosely turn in fixing plates from be-
low on the worktop and on the con-
nection bar.
7.
Put the subsequent appliance in the
worktop cut out . Make sure that the
front ends of the appliances are on the
same level.
8. Tighten the fixing plate / retaining grip
screws.
9. Seal the gap between the worktop
and appliances and between applian-
ces with silicone.
10. Put some soapy water on the silicon.
11.
Press the rubber shape with some
strength against the glass ceramic and
move it slowly along the space.
12. Do not touch the silicon until it be-
come hard, it can last about a day.
13. Carefully remove silicon that came out
with a shaving blade.
14. Clean glass ceramic fully.
Prod.Nr. 941 460 009 00
220-240 V 50-60 Hz
Made in Switzerland
1.8 kW