Technical Information; Rating Plate - Electrolux EQT4520BOG Benutzerinformation

18 www.electrolux.com
into the worktop cutout. Push it half of
its width under the hob.
7. Loosely screw in the fixing plates from
below to the worktop and to the
connection bar.
8. Insert next hob into the worktop
cutout. Make sure that the front edges
of the hobs are on the same level.

9. TECHNICAL INFORMATION

9.1 Rating plate

Modell EQT4520BOG
Typ 55 TEP 02 AO
Ser.Nr. .................
ELECTROLUX
9.2 Roasting zones specification
Roasting zone
Front
Rear
The power of the roasting zones can be
different in some small range from the
9. Tighten the fixing plates / retaining grip
screws.
10. Use silicone to seal the gaps between
the hobs and between the hobs and
the worktop.
11. Put some soapy water on the silicone.
12. Press the rubber shape with some
strength against the glass ceramic and
move it slowly along the space.
13. Do not touch the silicone until it
becomes hard, it can last about a day.
14. Carefully remove the silicone that
came out with a shaving blade.
15. Clean the glass surface.
PNC 941 460 009 01
220 - 240 V 50 - 60 Hz
1.8 kW
Nominal power (maximum heat set-
ting) [W]
900
900
data in the table. It changes with the
material and dimensions of the cookware.