Control Panel - Electrolux ST401SCN10 Benutzerinformation

48 electrolux
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
SERVICE
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
ENVIRONMENT PROTECTION
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1
Fan function switch
1
Fan light
Temperature regulator
2
Action Freeze button
Action Freeze indicator
3
SWITCHING ON
Remove, if present, the remove label stuck
on the inside of the freezer compartment.
Insert the plug into the wall socket.
SWITCHING OFF
To switch off the appliance remove the
mains plug.
TEMPERATURE REGULATION
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
• press the temperature regulator more
times until the LED corresponding to the
required temperature lights up. Selection
is progressive, varying from +2°C to
+8°C.
+2 +4 +5
2 3
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
+6 +8
A medium setting is generally the most
suitable.
However, the exact setting should be chos-
en keeping in mind that the temperature in-
side the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is
lower than 16°C press the temperature
regulator until the LED corresponding to the
lowest temperature lights up.
ACTION FREEZE FUNCTION
You can activate the Action Freeze function
by pressing the Action Freeze button more
times until the LED corresponding to the
symbol Action Freeze indicator lights up.
You can deactivate the Action Freeze func-
tion by pressing the Action Freeze button
more times until the required temperature is
selected.
are recyclable.