Electrical Connection; Rear Spacers; Door Reversibility - Electrolux SG254N12 Benutzerinformation

ELECTRICAL CONNECTION

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.

REAR SPACERS

Inside the appliance you find two
spacers which must be fitted as shown
in the figure.
Slacken the screws and insert the spacer
under the screw head, then retighten the
screws.

DOOR REVERSIBILITY

Warning! Before carrying out any
operations, remove the plug from the
power socket.
To carry out the following operations, we
suggest that this be made with another per-
son that will keep a firm hold on the door of
the appliance during the operations. Gently
lay the appliance on its back.
To change the opening direction of the
door, do these steps:
• Remove the clip-in ventilation grille, re-
move the plug (e) from the ventilation
grille and install it on the opposite side.
• Remove the bottom hinge (A) by un-
screwing the fixing screws.
• Remove the door.
• Unscrew the pin (f) of the bottom hinge
and install it on the opposite side.
A
• Unscrew the pin of the upper hinge and
install it on the opposite side.
• Install the door in the upper hinge.
• Install the ventilation grille, clipping it into
place.
electrolux 51
e
A
f