Troubleshooting - Vacmaster JOEY Bedienungsanleitung

GB
WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner. Failure to do
so could result in electrical shock or personal injury. Remove the handheld unit form the main body
if performing maintenance on the brush roll or motorised floor head.
Cleaning Performance
Vacmaster vacuum cleaners are tested for endurance. If your motor is operating, then the most
likely cause for a loss in suction is a blockage or an opening in the vacuum.
To maintain a high cleaning performance from your machine, it is important to replace or clean
filters as necessary. Empty full dust bin to prevent performance drops. A performance drop with
clean filters can only be caused by a blockage in the tools or the hose connections.
PROBLEM
Vacuum will not
power on.
Battery charge
indicator does not
illuminate.
Motorised brush
not turning.

TROUBLESHOOTING

POSSIBLE CAUSE
Battery may be depleted.
Wrong charger being used.
Handheld vacuum cleaner is not
installed properly.
Charging connector is not fully
plugged into the charging base.
Charging plug is not fully plugged
into outlet.
Charging adapter is not plugged
in.
Debris accumulated on the metal
charge contacts on the handheld
vacuum cleaner, main body and
charging adapter.
Brush roll is jammed.
Brush roll needs to be reset.
Brush roll is not installed correctly.
Charge the battery as instructed on
page 8.
Be sure to use only the charger
supplied with your product.
Remove handheld vacuum cleaner
and reattach ensuring that it is
securely in place.
Be sure the charging connector is
fully inserted in the charging base.
Be sure charging plug is fully plugged
into outlet.
Be sure the charging adapter is
plugged in properly to the power
supply and to the charging port on
the side of the charging base.
Be sure no debris is accumulated on
the metal charger contacts on the
handheld vacuum cleaner, main body
and charging adapter.
Remove obstruction. Follow
instructions on page 11.
Turn the unit off and remove the
obstruction, then turn back on.
Remove brush roll and reinstall
following instructions on page 11.
12
SOLUTION