Vacmaster JOEY Bedienungsanleitung Seite 9

Battery charging indicator
Flashing light
No light
8) When fully charged, unplug the charging adapter from the power supply and remove the
vacuum cleaner from the charging base.
NOTE: If the battery charging indicator does not illuminate when charging, ensure that:
• The vacuum cleaner is seated properly onto the charging base.
• The charging plug is plugged into the power supply properly.
• The power supply is switched on.
• The charging connector is fully inserted in the charging base.
2. Using Your Vacuum Cleaner
Before vacuuming, check that the brush roll is clear from any obstructions such as hair or sharp
objects to avoid scratching floors, and that the dust bin is empty.
NOTE: Use the low-speed setting for cleaning of hard floors, and low pile rugs, or when an
increased run time is needed. The high-speed setting should be used for cleaning plush rugs and
carpets or when additional cleaning power is required.
1) To start the vacuum cleaner, press the power switch. The
vacuum cleaner will start in the high speed mode.
2) To switch to the low-speed setting, press the speed switch
once. Press the speed switch again to switch back to high
speed.
3) To stop the vacuum, press the power switch once.
3. Using Your Handheld Vacuum Cleaner
1) To remove the handheld vacuum cleaner, press the handheld vacuum cleaner release button
and detach from the main body (Fig. 12).
2) To turn on, press the power switch located on the handle.
To turn off, press the power switch located on the handle
again.
3) To clean areas that are difficult to reach, use the combination tool provided by inserting one end
of the tool into the handheld vacuum cleaner suction port (Fig. 13).
4) The combination tool can be used as a crevice tool or a dusting brush. To transition from
crevice tool to dusting brush, disengage the latch located on the back of the tool, and slide the
brush to the top. Ensure it clicks into place to secure for operation (Fig. 14).
5) To return the combination tool back to the crevice function, press the latch release button once
more and slide the brush back into the bottom position. Ensure it is securely locked into place.
Status
Charging
Fully charged
9
GB
Power Switch
& Battery
Charging
Indicator
Power Switch
Speed Switch
Power Switch
& Battery
Charging
Indicator