Troubleshooting - Vacmaster VZA0708P Bedienungsanleitung

WARNING:

TROUBLESHOOTING.

Cleaning Performance
Vacmaster vacuum cleaners are tested for endurance. If your motor is operating, then the most
likely cause for a loss in suction is a blockage or an opening in the vacuum.
To maintain a high cleaning performance from your machine, it is important to replace or clean
pre-filters as necessary. Replace full dust bags to prevent performance drops. A performance drop
with clean filters can only be caused by a blockage in the tools or the hose.
PROBLEM
The appliance does not work.
Dust is escaping from the
motor cover.
The power cord cannot be
retracted.
Low suction power and high
operating noise / vibrations.
TROUBLESHOOTING
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
POSSIBLE CAUSE
No power.
The plug is not plugged into the
power source.
Motor overheating protection
during use.
Functional fault in the power
cord, switch, or motor.
The exhaust filter is missing,
damaged or not fully installed.
The pre-filter is missing or
damaged.
The air inlet filter is missing or
damaged.
The power cord is stuck.
Dust bag is full.
Suction nozzle, hose, or tank inlet
is blocked.
The pre-filter or air inlet filter
needs to be cleaned.
Check the power supply and
fuse.
Insert the plug into the power
source.
Unplug the power cable, check
whether the dust bag is full and
the pre-filter is blocked. Replace
the dust bag or clean up the pre-
filter, wait for the motor to cool
before restarting it for use.
Have the damaged part checked
by qualified personnel or contact
the after sales helpline.
Ensure the exhaust filter is
correctly installed or replace if
damaged.
Ensure the pre-filter is correctly
installed or replace if damaged.
Ensure the air inlet filter is
correctly installed or replace if
damaged.
Fully release the power cord and
retract it again.
Replace the dust bag.
Check the suction nozzle, hose,
and tank inlet for obstructions.
Check and clean the pre-filter
and air inlet filter. Replace if
damaged.
13
SOLUTION
GB