Operation; Special Accessories - Hansgrohe Axor Allegroh Montageanleitung

Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of equal
pressures.

Operation

The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
36010XXX: A parabolique jet is obtained by
turning the spout through 180°.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5 bars.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(8a) located behind the aerator must be removed.
8
English
To adjust the hot water limiter on single lever mixers,
please see page 15.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 4)
1
1.1 screw cover
1.2 mouth spray connection
2
3
4
5
6
7
8
9
10
10.1 pull knob
7 l/min 3 bars
11
14 l/min 3 bars
12
max. 10 bars
13
1 - 5 bars
16 bars

Special accessories

max. 80° C
X
65° C
XXX = Colors
000 chrome plated
090 chrome/gold plated
880 satin chrome
®
handle without mouthspray
connection
handle with mouthspray
connection
flange
cartridge without mouthspray
connection
cartridge with mouthspray
connection
service set
nut
seals (5)
mixer ball without mouthspray
connection
mixer ball with mouthspray
connection
mousseur cpl. (10)
mousseur gold plated
spout cpl.
pull rod cpl.
fixation cpl.
connection hose
holder with 3 nozzles
special tool set
(not part of delivery)
36092XXX
36091XXX
94063XXX
94185000
94130XXX
14095000
14098000
13952000
13918000
13962000
13964000
13097000
13085000
94980990
16081XXX
92620XXX
94066XXX
13961000
94076XXX
13196XXX
58085000