Operation; Spare Parts; Technical Data - Hansgrohe Axor Uno 13450 Serie Montageanleitung/Garantie

Assembly
1. Flush through the supply pipes.
2. Mount the ball S - unions.
3. Fasten the mixer using ball union nuts, align and
tighten it.
The ball - S - unions enable inaccuracies in the wall
installation to be compensated for, whether in the
horizontal direction, in the vertical direction or in
the parallel orientation.
4. Fit on the spout body / shower hose connection and
tighten the allen screw.
5. Push the moulding strip onto the rim of the
escutcheon.
6. Add the escutcheon and tighten the nut.
7. Fit on flange.
8. Mount the lever head, tighten the allen screw and
fit on stopper.
Large differences in pressure between the hot and cold
water supply should be balanced.
If so wished, the bath spout can be installed in such a
way that the bath/shower selecter knob is on the left
and the hose connecting piece is on the right. To do this,
proceed as follows:
Remove the complete diverter casing. Unscrew allen
screw at the back of the divertercasing. Remove spout
and cover and mount them on the reverse side. Mount
the spout on the mixer body.
The hose connecting piece turns 360°.

Operation

The mixer is actuated by pulling the lever head.
Swivel to the left = hot water, swivel to the right = cold
water.

Technical Data

Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water
temperature:
Centre distance:
Connections:
Rate of flow:
6
English
max. 10 bars
16 bars
max. 80° C
65° C
150 ± 16 mm
right - hot left G ½"
approx.22 l/min
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5 bars.
To adjust the hot water limiter on single lever mixers,
please see page 12.
No adjustment is necessary when using a continuous
flow water heater.

Spare parts

1 handle
1.1 screw cover
2 flange
3 escutcheon
4 nut
5 cartridge cpl.
6 service set
7 seals
8 mixer ball
9 ball S - unions
ball S - unions 120 - 180 mm
10 selector cpl.
11 diverter knob cpl.
12 aerator cpl.
13 spout cpl.
14 noise reduction
15 non return valve
XXX= Colors
030 chrome/blue
330 blue
430 red
450 white
480 yellow
580 yellow/satin chrome
610 black
13690XXX
94063XXX
13984XXX
13983XXX
94106000
14096000
13952000
13962000
13964000
13989000
13988000
94155000
13471XXX
13485000
93450XXX
94073000
94074000
6