Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms.
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing washer in
position on the basin.
3.
Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4.
Connect the supply pipes to the isolation
valves;
cold right - hot left.
5.
Connect the pull rod to the pop-up waste.
The pressures of the cold and hot water connections
must be balanced.
Technical Data
This mixer series-produced with waterdim-
mer
(flow limiter).
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0.3 MPa
Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate 10020XXX:
Operation
open
English
7 l/min 0.3 MPa
max. 1 MPa
1.6 MPa
max. 80° C
65° C
WRAS
close
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled con-
tinuous flow heaters if the flow pressure is at least
0.15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(4a) located behind the aerator must be removed.
Spare parts (see page 3)
1�
flange
2�
handle
3�
cartridge cpl.
4�
aerator cpl.
5�
pop up rod
6�
connection hose
7�
fixing set
8�
extension hose 300 mm
9�
lever arm cpl. 200 mm
lever arm cpl. 340 mm
Special accessories
X
special tool set
(not part of delivery)
XXX = Colors
000 chrome plated
810 satinox
cold
®
96427X X X
10090XXX
96339000
94005XXX
94006XXX
96316000
13961000
13098000
96007000
96324000
58085000
hot
Werbung
