Operation; Placing The Product; Boiling Water; Cleaning And Care - Silvercrest SWGF 2400 B1 Bedienungs- Und Sicherheitshinweise

˜ Operation
m
Danger of burns! The lid 3 must remain
closed when pouring hot water . Otherwise,
hot water or steam could escape over the rim
causing burns .
˜ Placing the product
Keep the power cord 6 as short as possible .
Wrap the excess power cord onto the cord
storage 8 (bottom of the base 9 ) .
Guide the power cord 6 through the power
cord guide 7 .
Place the base 9 on an even, stable surface .
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam .
˜ Boiling water
Fill the water kettle 12 with water through the
lid's 3 filler flap 2 .
Place the water kettle 12 onto the base 9 .
Push the I/O switch 4 into the I position .
The LED ring 10 (on the bottom of the water
kettle 12 ) lights up . The colour of the LED ring
changes with the water temperature .
Colour Temperature (approx.)
Green
Blue
Purple
Yellow
Red
The product automatically turns off when the
water is boiled .
≤ 50 °C
51–70 °C
71–80 °C
81–90 °C
> 90 °C
˜ Cleaning and care
m
WARNING! The product shall not be
immersed in water or other liquids . Do not
hold the product under running water .
Always disconnect the product from the power
supply before cleaning .
Check the product prior to each use for visible
signs of damage .
˜ Cleaning
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product .
Clean the product with a slightly damp cloth .
Use a mild detergent, if necessary .
Rub all parts dry with a clean cloth .
˜ Care
Cleaning the strainer 1
Remove the lid 3 .
Gently pull on the strainer's 1
clip to release it .
Rinse the strainer 1 with fresh
water .
Place the strainer 1 with its top
edge on the top of the water kettle
12 .
Press the strainer 1 firmly into
position .
Removing calcifications
Limescale reduces the efficiency of the product
and increases energy consumption . Check the
product regularly for limescale deposits .
Fill the water kettle 12 with a vinegar solution
(5 to 15 %) .
Push the I/O switch 4 into the I position .
Wait for the product to turn off automatically .
Fig.
B
C
–
D
E
GB/MT 27