Charging The Clipper - BaByliss E702XTE Handbuch

ENGLISH
CLIPPER
E702XTE/E702YTE
. 2 cutting guides for 22
lenghts (from 3 to 18mm and
from 21 to 36mm, in 1.5mm
steps)
2. 1 precision guide
5 positions (0.5 to 2.5mm)
3. Blades:
Moveable blade:
- Sharpened using 3D etching
process: for an exceptionally
sharp cutting edge.
Fixed Blade:
- Titanium coating: for longer
life.
These two technologies provide
perfect surface condition and their
combination is optimal for reducing
the friction coefficient.
4. Turbo function
5. ON/OFF switch
6. Cutting length control knob
7. Lateral display of selected
length
8. Charging indicator light
9. Plug for use on the mains and
for charging
0. Cleaning brush and comb

CHARGING THE CLIPPER

Before using the clipper for the
first time, allow it to charge for 6
hours.
. Connect the transformer to the
mains and the plug into the
unit. (Fig. 1)
2. Check that
indicator light is lit and that the
the charging
switch on the trimmer is in the
OFF position.
3. A fully charged trimmer will run
for 30 minutes.
MAINS USE
Connect the transformer into the
mains, wait  minute and then
switch into the ON position.
IMPORTANT!
transformer provided with the
E702XTEXDE/E702YTE
Voltage = 2.4V - Tension =
000mA
TURBO
For an extra burst of power,
push the TURBO button on the
top side of the clipper. This will
boost the motor of your clipper,
producing faster cutting action
and increased cutting power for
the more difficult cutting tasks.
USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the
cutting guide BEFORE turning the
trimmer on, and turn it off before
changing the guide.
To attach the cutting guide,
first adjust the cutting length to
3mm or 2mm and place it on
the support guide adjusting first
both sides and then pushing on
the bottom of the guide until you
hear a 'click' . (Fig. 2)
To remove the cutting guide, first
6
Use only
clipper
the