Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
cLIppER
E702XTE/E702YTE
1. 2 cutting guides for 22
lenghts (from 3 to 18mm and
from 21 to 36mm, in 1.5mm
steps)
2. 1 precision guide
5 positions (0.5 to 2.5mm)
3. Blades:
Moveable blade:
- Sharpened using 3D etching
process: for an exceptionally
sharp cutting edge.
Fixed Blade:
- Titanium coating: for longer
life.
These two technologies provide
perfect surface condition and their
combination is optimal for reducing
the friction coefficient.
4. Turbo function
5. ON/OFF switch
6. cutting length control knob
7. Lateral display of selected
length
8. charging indicator light
9. plug for use on the mains and
for charging
10. cleaning brush and comb
IMpORTANT
REGARDING
THE
BATTERIES OF THIS UNIT
To obtain and maintain the
longest
battery
possible, allow it to charge for 16
hours before using it for the first
time and then approximately
every
three
INFORMATION
NI-MH
autonomy
months.
Full
7
autonomy of the unit will only be
obtained after three complete
recharge cycles.
cHARGING THE cLIppER
Before using the clipper for the
first time, allow it to charge for 16
hours.
1. Connect the transformer to the
mains and the plug into the
unit. (Fig. 1)
2. Check
that
indicator light is lit and that the
switch on the trimmer is in the
OFF position.
3. A fully charged trimmer will run
for 30 minutes.
MAINS USE
Connect the transformer into the
mains, wait 1 minute and then
switch into the ON position.
IMPORTANT!
Use
transformer provided with the
E702XTEXDE/E702YTE
Voltage = 3.0V - Tension =
1000mA
TURBO
For an extra burst of power,
push the TURBO button on the
top side of the clipper. This will
boost the motor of your clipper,
producing faster cutting action
and increased cutting power for
the more difficult cutting tasks.
USING THE cUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the
the
charging
only
the
clipper
Werbung
